FAO: anyone fitting new wishbone ball joints.
The new rear bolt that comes with it, is splined
and needs to be pressed in!
Well the ones I got from ROC do, some on ebay seem
to have it done already?!
Marco last edited by
From my experience if you just tighten the nut on to it, the splines will cut through themselves by the tightening action :) So no press needed
Phew! Thanks for replying Marco,
not actually done it yet was going to press them in today at work,
guess I wont bother then :D
Mikey last edited by
I can confirm what Marco says. They will pull in, just use a big ass breaker bar to tighten them up to make life a bit easier!
Broke my vice trying to press them in! Cast Iron fcuker too!!
aye, massive breaker bar did it :D
Mooneggs last edited by
just because I haven't seen it… what does FAO mean??
For the attention of. :)