Distributor/Camshaft Position Sensor Wiring Diagram



  • Good evening from the States! I've come across a bit of a problem with the 1.6 SOHC that we've got. Since we've had the car, the CEL has always displayed a 3 code, the No G-Signal. Vehicle was working incredibly well even with the bad CPS (I believe it was just going out, not completely dead as randomly the car would not start, then fire right up after a few minutes of sitting. Two weeks ago it becomes more and more prevalent until finally the engine stops starting.

    Narrowed it down to two things; the CPS or the fuel pump relay/fuel pump. Purchased a distributor from an online vendor which source the distributor for the Euro spec 1.6 SOHC (the CPS is completely different from the US spec position sensors).

    This is how our CPS is designed

    A bit different than what's run in the Kias and Mazdas over there.

    Anyway, I believe that the wiring should be the same as over here the CPS female end is different as well, ours is rounded where as yours should be square (unless the vendor replaced the CPS with something different even though it's "New").

    So, any wiring diagrams for your distributors would be awesome as far as color goes.


 

Copyright 2021 UK-MX3.com | Powered by NodeBB