No rear tie bar on 1.6?!



  • @98c4820ddf:

    4 cylinder owners: your car is missing an important part especially if you have aftermarket wheels and/or lowered suspension! This tie bar installs in minute with basic tools and helps to maintain the rear suspension's geometry under hard cornering.

    If so does a V6 one fit straight on?



  • should do chassis and struts appear to be all the same on all of them, they wouldnt make a different strut mount costs would be too much, they just left the cheaper cross member off



  • Just to hijack away like I always do, anyone know of any company that does uprated ARB's for the MX3 as mine is looking slightly dead….. :roll:



  • Whiteline do a chunky solid one. Rear is recommend being FWD

    And yes the rear tie bar even fits 323BGs that also lost out on them.



  • @268bb320b4=Marco:

    Whiteline do a chunky solid one. Rear is recommend being FWD

    And yes the rear tie bar even fits 323BGs that also lost out on them.

    Cheers Marco, I wasn't sure if it was Whiteline that did them.

    Yeah, it's for the rear, it was looking kinda rotten when I was under the car last week (actually, most of the suspension was looking rather sorry for itself if I'm honest, probably could do with the whole lot being ripped out and replaced next year and possibly powder coated for good measure :wink: ).



  • @9d48d4c782=nightstalker:

    @9d48d4c782=Marco:

    Whiteline do a chunky solid one. Rear is recommend being FWD

    And yes the rear tie bar even fits 323BGs that also lost out on them.

    Cheers Marco, I wasn't sure if it was Whiteline that did them.

    Yeah, it's for the rear, it was looking kinda rotten when I was under the car last week (actually, most of the suspension was looking rather sorry for itself if I'm honest, probably could do with the whole lot being ripped out and replaced next year and possibly powder coated for good measure :wink: ).

    everything under a mazda looks rusted to shit but its still strong unlike the new ones ;)



  • @78bb28d096=DaveMc:

    @78bb28d096=nightstalker:

    @78bb28d096=Marco:

    Whiteline do a chunky solid one. Rear is recommend being FWD

    And yes the rear tie bar even fits 323BGs that also lost out on them.

    Cheers Marco, I wasn't sure if it was Whiteline that did them.

    Yeah, it's for the rear, it was looking kinda rotten when I was under the car last week (actually, most of the suspension was looking rather sorry for itself if I'm honest, probably could do with the whole lot being ripped out and replaced next year and possibly powder coated for good measure :wink: ).

    everything under a mazda looks rusted to shit but its still strong unlike the new ones ;)

    I beg to differ, I am quite concerned about the underside of my car and also the chassis rails (They's bendy yO!!).


 

Copyright 2021 UK-MX3.com | Powered by NodeBB