Garfy1981's - KLZE MX3 uppdated 04/10

Posted: Fri Apr 16, 2010 7:52 pm

Come on garfy spill the beans! What is it?? Looks like some sort of ECU, can't work out the lead though, looks like an old printer lead LOL! What I wanna know is, is it gonna make your KLZE quicker? if yes I definately need to know!!!! LOL Laughing

Moderator Joined: 07 Aug 2006 Posts: 392 Location: kent

Well i hope so lol, its megasquirt stand alone ecu. Will remove the Kl36 and install megasquirt, can then remove the VAF ( which removing that alone should free up some hp! ) a small IAT sensor goes in its place.
Dyno tune everything up and hopefully free up some Hp. Dont know when it will be installed as im still looking for a AEM UEGO AFR guage to monitor the air fuel ratios.
Marco is also using same system but his system is a bit more advanced than mine!!.

oh sorry guys i have no intention of selling kl36 and je50. Keeping it as a back up fail safe!.

Posted: Fri Apr 16, 2010 8:23 pm

Have you got to replace dissy with coil packs?? Would like to go down the stand alone ecu route myself but can't afford/warrant OMEX, and too stupid fo megasuirt, unless a certain someone can help Wink

Looking forward to japfest to see everyones cars and faces etc...........

Whats the megasquirt setup gonna cost in total if you don't mind me asking?

Moderator Joined: 07 Aug 2006 Posts: 392 Location: kent

Trust me mate I'm not megasquirt smart either I brought it for whole issue of plug and play. My system should use stock dizzy. Marco is running coil packs which do give greater control but I can upgrade to that at a later date. The set was 400 dollars shipped. I didn't want to spend too much as i'd rather have a LSD if the two were closely priced.

Looking forward to japfest too! Smile

Moderator Joined: 07 Aug 2006 Posts: 392 Location: kent

http://www.youtube.com/watch?v=chhzV2O3nEA

Local Joined: 04 Mar 2007 Posts: 166 Location: nottingham

hmm i like the look at that. how much was it garfy?

Moderator Joined: 07 Aug 2006 Posts: 392 Location: kent

bad news!!!, years worth of sitting has left polished manifold looking very sorry for itself, two hours of megaris and buffing later still not looking good!, to the point where i dont even want to take it to japfest now!!, hoping i can find a powder coaters to do a fast turn around job. Otherwise its going to look pants!!.

Hate damm polished manifold now!!, takes too much tlc to keep it looking nice!, just want it sprayed and i can just wash engine bay and end of!!.

Dont want to spray it myself in situ, rather is was pro done.

watch this space i guess!!. Sad

Posted: Mon May 10, 2010 8:07 pm

i want one megasquirt that is